✅ MPPT:
The MPPT of the 1500W wind turbine is situated externally. The MPPT is specially designed for each wind turbine, the special design allows you to get the most power out of the wind turbine as well as to protect your wind turbine from overcharging.
Why Use Our Power Station
Our power station has been specially designed to handle a hybrid power situation. It can draw power from solar panels as well as wind turbines to supply you with the combined power. If the generated power is insufficient, the power station allows you to charge the power station via an AC Outlet directly. The outlet of the power station is serge protected, in case there is a short at one of the input ports the connected devices to the Power Station are protected.
The Power Station gives you control of the power flow going to your Power Station. The default setting on the Power Station is to only charge from the Green Energy devices. If the green energy is not producing enough power in the limited time you need there is an option for you to charge the device directly from an AC outlet. There is a Voltage meter and an Ampere meter to show the status of the power bank.
How To Use Our Power Station
The Power Station is easy to install on your green energy devices and even easier to operate and control once installed properly. All the information on how to install and operate the Power Station is in our clearly stated instruction manual.
There is a breaker switch for your Wind Turbine on the Power Station, for your convenience not to run to the wind turbine to manually put on the braking switch.
Where Can Our Power Station Be Used
The Power Station can connect up to 3 solar panels, a wind turbine, and an AC input to power up the Power Station.
The Power Station can be situated in areas near where your green energy power equipment is for them to be charged and used. Since the Power Station is movable, once the Power Station is charged you can move it to an area where you need electricity to be supplied.
| PRODUCTS INCLUDES |
| POWER STATION |
| 1 x On / Off Switch |
| 1 x Circuit Breaker |
| 2 x AC Output |
| 1 x Remote Port |
| 1 x External Additional Battery Connection |
| 3 x Positive & Negative Connections for Solar Panels |
| 1 x RST Connection to Wind Turbine |
| 1 x AC Input Connection |
| 1 x Ampere Meter |
| 1 x Voltage Meter |
| 1 x Emergency Breaker Switch for Wind Turbine |
| SPECIFICATION | |
| Model Number: | BOX-1500 |
| BATTERY | |
| Normal Voltage: | DC 24V |
| Capacity: | 2 x 100 A/HR |
| Life Cycle: | >200 Times |
| DIN Type Battery: | 5.2 L |
| Terminal Type: | B2 |
| Operating Temperature: | -20°C ~ +50°C |
| Dimension: | 388 x 217 x 170 mm |
| Weight: | 32.5 kg |
| OPTIONAL | |
| SOLAR PANEL | |
| Rated Power: | 3 x 50W (150W) |
| Rated Voltage: | DC 12V |
| Short Circuit Current: | 2.28A |
| Open Circuit Voltage: | 22.03V |
| Max. Power Current: | 2.69A |
| Operating Temperature: | -40°C ~ +85°C |
| Dimensions: | 925 x 330 x 25 mm |
| Weight: | 10.9 kg |
| SOLAR MPPT CHARGE CONTROLLER | |
| Open Circuit Voltage: | DC 25V |
| Max. Charge Current: | 30A |
| Battery Charge Voltage: | DC 14.3V ± 4% |
| 1500W PURE SINE WAVE INVERTER | |
| Max. Continuous Power: | 1500W |
| Surge Power: | 3000W |
| Wave Form: | Pure Sine Wave |
| DC Input Voltage: | 12V (10.5~15V) |
| AC Output: | 110V / 220V |
| Efficiency: | Up to ≧90% |
| Protection:
| Low Battery Shutdown Input Overload Voltage Temperature Overload Short Circuit Shutdown |
| Soft-Start System: | Yes |
| Remote Control: | Yes (Optional) |
| Internet Of Things (IoT): | Yes (Optional) |
| Dimension: | 30.4 x 18.1 x 8.2 cm |
| Weight: | 2.25 Kgs |
| Battery Protection Voltage: | 12V – 14.4V (Lead-Acid Batteries) 15.8V (Deep-Cycle Batteries) 24V – 28.8V (Lead-Acid Batteries) 30V (Deep-Cycle Batteries) |
| Rated Load Current: | Max. 35A |
| Over-speed Braking: | ≦1400RPM |
| WIND TURBINE 1500W | |
| Rated Speed: | 14m/s (46ft/s) |
| Rated Power: | 1500W |
| Voltage with MPPT: | 24V |
| Rotor Diameter: | 1.7m (5.6ft) |
| Cut-In Wind Speed: | 2.5m/s (5.6mph) |
| Survival Wind Speed: | 60m/s (134mph) |
| Suggested Battery Capacity: | >200 A/Hr |
| MPPT Charge Controller: | External (Included) |
| Generator: | 3 phrase AC |
| Number Of Blades: | 3 |
| Blade Material: | PP + Glass Fiber |
| Weight: | 15Kg |
| WIND TURBINE 1500W MPPT CHARGE CONTROLLER | |
| Output Power: | 24V Auto-Detect |
| Input Voltage Range: | 5 ~ 75 VRMS |
| Charging Efficiency: | >95% |
| Battery Protection Voltage: | 29.5±1V (Lead-Acid Batteries) 31±1V (Deep-Cycle Batteries) |
| Rated Load Current: | Max. 45A |
| Over-speed Braking: | ≦1000RPM |
Reviews
There are no reviews yet.